DSN-DM/Z DSN-DM/Y Indoor Electromagnetic lock

DSN-DM/Z DSN-DM/Y Indoor Electromagnetic lock

• Specification
• Technical Parameters

• DSN-DM/Z DSN-DM/Y Indoor Electromagnetic lock

  DSN-DM type indoor electromagnetic lock is used for 3.6 ~ 40.5 KV rated voltage and frequency of 50 hz indoor high voltage electrical equipment. With pillar type voltage sensor, used to run personnel provide information on the condition of the circuit voltage switch equipment installation place and function of subject to compulsory atresia, assembly before all kinds of switch cabinet, the back door and other parts need to be blocking, prevent electrical wrong operation, prevent into charged interval, improve the product of form a complete set of error prevention performance.

  Warning: only by the display of charged display device was not enough to prove the system has not been charged; Like to run the program as a mandatory requirements, should also be used in accordance with the relevant IEC 61243 voltage detector or voltage detection device.

  Using the environment conditions

  1.Ambient temperature: the upper limit of no more than +40℃, the lower limit of not less than -25℃, a special area of not less than -35℃

  2.Altitude: not more than 1000m above sea level Area

  3.Atmospheric conditions: air relative humidity on average less than 95%, on average less than 90%; daily average water vapor pressure less than 2.2kPa, on average less than 1.8kPa

  4.Environmental conditions: no significant contamination, non-flammable, explosive chemicals and salt spray spaces

  Product features

  ☆Unlock the direction and lock in the same direction, unlock keys can be used to after the unlock, continue to spin can directly open the lock,  convenient operation.

  Execution standard:JB/T7827-95

  IEC 61958：2000  DL/T538

   

• Installation hole size shape

  

  

  Models and meaning

  

  Back view the wiring diagram

  

  Note: the so-called installed the left or right, refers to the operator to lock objects (such as lever, cabinet put oneself in another’s position fixed part),  the corresponding installation position. When electromagnetic locks in the lock on the object location, is located in the operator to the left side is the left side of the installation, on the other hand, is on the right side of the installation.

   

  Electromagnetic lock is chosen, and basic parameters

  Order No.	Model	Electromagnetic lock according to the luminous component			Electromagnetic lock operating voltage (V)	Installation	Dimensions and installation hole size chart	Back asthe wiring diagram	Remark
  		Type	operating voltage (V)	Effective life (h)
  D-13	DSN-DMY1	Ultra-high brightnesslight-emitting tube	<DC2.5	>30000	AC220DC220	Right open	Figure 1	Figure 3
  D-14	DSN-DMY3				DC110	Right open	Figure 1
  D-15	DSN-DMY4				AC110	Right open	Figure 2
  D-16	DSN-DMZ1				AC220DC220	Left open	Figure 2
  D-17	DSN-DMZ3				DC110	Left open	Figure 2
  D-18	DSN-DMZ4				AC110	Left open	Figure 1
  D-19	DSN-DMY6				DC6	Right open	Figure 2		Designed with uninterruptible power supply.
  D-20	DSN-DMZ6				DC6	Left open	Figure 2

  Ordering instructions

  1. To order this product, please indicate the type, voltage sensor model, please refer to our company sample voltage sensor.

  2. If you have special requirements can be negotiated with our company.