High Voltage Cabinet Maglocks DSN-AM/DSN-BM Indoor Electromagnetic Locks

Use Conditions of High Voltage Cabinet Maglocks DSN-AM/DSN-BM Indoor Electromagnetic Locks

1. Ambient temperature: the upper limit of no more than +40 º C, the lower limit of not less than -25 º C, a special area of not less than -35 º C

2. Altitude: installation area is not higher than 1000 m above sea level

3. Atmospheric conditions: air relative humidity, average no greater than 95%, on average no greater than 90%; Water vapor pressure, average no more than 2.2 kPa

4. Environmental conditions: no obvious impurity, no inflammable, explosive chemical corrosion and salt fog.

DSN-AM/DSN-BM Electromagnetic Cabinet Lock Installation Steps

1. Remove the M5 nut, spring washer and flat washer of the panel mounting screw in sequence;

2. From the outside of the cabinet door, put the bolt side of the lock body into the opening first, then turn the lock body so that the mounting screw on the panel. smooth;

3. From the inside of the cabinet door, install the flat washer, spring washer, and M5 nut on the M5 screw on the lock panel, and finally tighten the M5 nut.

Instructions of Using DSN-AM/DSN-BM Electromagnetic Cabinet Lock

(1) Normal operation steps

A. Lift the button, the power supply connected, electromagnet coil electricity action, moving iron core from the lock block, the lock indicator, that allows the lock.

B. Turn the handle towards the lock (left side clockwise, counterclockwise) right, continue to exert oneself to do, when to limit position lock switch will automatically lock the lock open position, can open cupboard door. If you don’t have to lock open position,the lock will automatically return to the lock position and meet the automatic reset function, such as lock the lock in the open position, need to artificially will turn the handle to open the lock in the opposite direction, namely lock return to lock in position, so as to meet the blocking state.

Note: A, B lock appearance and installation dimensions are the same  Operation method: A. toggle button B. pull the lever.

(2) Manual unlock step:

A. lift the button, the power is locking loop force disconnect, lock indicator is not on, moving iron core stuck lock block, will show that are not allowed to open the lock;

B. special circumstances must be unlock, to get an unlock key, insert the unlock empty inside, turned the key in the direction shown by the panel marked 90 DHS to “a” or “a”, anchored off a lock of moving iron core block;

C. (with normal operation steps step B), in order to meet the “manual unlock” function.

Note: to unlock the key to unlock process, it is anchored off a lock of moving iron core block, to remove the effect of blocking state, and the lock must use dial button or lever to move the lock bolt, achieve the lock, so you can’t directly with the unlock key lock.

Models and Meaning of DSN-AM/DSN-BM Indoor Electromagnetic Locks

Note: The installation of the so-called left side or right side installation, means the operator lock the object-oriented (such as operating lever, cabinet fixed part), corresponding to the installation location.

When the electromagnetic lock installation location on the lock objects were located in the left-oriented operation that is installed on the left, on the contrary, is the right of the installation.

Parameters of DSN-AM/DSN-BM Indoor Electromagnetic Locks

Dimensions of DSN-AM/DSN-BM Indoor Electromagnetic Locks